|
Cause |
Solution | |
|
Not enough drying time between coats. |
Under normal conditions, finishes dry in 20 - 30 minutes. High humidity extends drying time. | |
|
Restorer no properly diluted or applied too frequently. |
Follow label instructions. Overuse can leave a sticky residue. | |
|
Restorer / maintainer not burnished soon enough after application. |
When dry, restorer / maintainer will continue to soften finish if not burnished. | |
|
Floor not properly rinsed before application of finish. |
Thoroughly rinse and neutralize floor after stripping. Use neutral cleaner in proper dilution. | |
|
Improper use of disinfectants. |
Measure carefully and follow label directions. | |
|
Separation of finish. |
Finish may have been exposed to prolonged heat or cold. Shake or stir before using. | |
|
Alkaline or detergent contaminated tile. |
Make sure to rinse floor until pick-up water remains clear. When recoating, make sure no cleaner residue remains on floor - rinse with clean water to prevent problem. | |
|
Finish is applied too thick. |
Apply thin coats and allow each coat to dry before applying the next coat. |
Monthly Special
